Clean Cameo 3 Mat

Make sure to store your mat flat with the cover sheet over the adhesive.

Clean cameo 3 mat.

Spread across your mat. If your mat is bent use books to help flatten it. Soap and water scrub your mat with soap and water using a sponge or a magic eraser. Thank you so much for posting this including and especially the solution.

Let it air dry when finished. Use a spoon or knife to apply the paste to the mat gently rub the paste into the mat and wash it off. Thanks again for sharing. Your mat will be wet but don t use a towel to dry it.

Once this is cleaned reasonably well wipe over your mat with a baby wipe. Here s how it works. Place your material in the top upper left corner of the mat as shown in silhouette studio. If you are using any previous silhouette cutting models cameo 3 portrait 2 etc you must use a cutting mat to cut out cardstock or other paper materials.

Goo gone i have a slight addiction to goo gone. First of all use your scraper to clean off all the debris that has built up on the mat. If you have a lot of built up fuzz or have been using high fiber materials such as fabric or handmade paper gently clean your mat with warm water. In most cases there are two quick fixes that will fix the issue and get you cutting successfully in a hurry.

This tutorial shows users how to clean their silhouette cameo autoblade to ensure proper cutting subscribe to our chan. If you haven t removed the protective liner from the cutting mat remember to do that now. Mix together two tablespoons vegetable oil and three tablespoons baking soda into a paste in a small sealable container. This worth saving that you can protect your mat later.

How to clean your silhouette cameo with alcohol cotton swab and a toothpick. One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing. Wait for 15 minutes and. Next the pop out cut feature can be used only with the cameo 4 machine line.

Connect the silhouette cameo 3 to your computer using its provided usb cable. I have worked on this problem for a few days and posted a thread yesterday called cutting top of mat silhouette cameo 3 i received numerous helpful questions and suggestions but the cure was following the suggested solution above. Additionally pop out cut mode is not intended for thin or flexible materials like copy paper or fabric. The same goes for the portrait 2 autoblade.